One piece of flat steel approximately 1.25 inches wide and 3/16” thick. Bend the ends to the correct angle (to be determined later) to mount the rear support brackets to the frame. The parts will be approximately 2” on one side and 3 or 4” on the other. As shown later, the long leg will have slots milled in them to provide some adjustment up or down for the frame at the rear.

You will also need various hardware such as bolts, nuts, washers, paint,etc.

This ends Part 1. The next part is Fabrication of the Parts.


Part 2: Fabricating the Parts.


Read more: http://scootdawg.proboards.com/thread/23163#ixzz2oyI7Pken